Fast precise dry drilling of tiles and stone using corded high-speed drills.
These bits work best at high speeds.
Max Rpm: 14 000
Important: ROTARY USE ONLY.
Must not be used on Hammer function.
To start drilling, place the drill at a 30-degree angle.
Drill until the tile bit starts to penetrate the material.
Once the hole has started to form, bring the drill to an upright position, and continue.
Top Tip
These drill bits mill they don’t drill, so excessive pressure is not necessary.
As the tile bit starts to mill the heat will melt the wax filling, lubricating the cutting surface.
Periodically remove the bit from the hole to allow for cooling.
For horizontal drilling minimal pressure is required, for vertical drilling the weight of the power tool will usually provide sufficient pressure.
5 mm
HEXVBDC5
0606110038614
DRY AND WET
6 mm
HEXVBDC6
0606110038621
DRY AND WET
8 mm
HEXVBDC8
0606110038638
DRY AND WET
10 mm
HEXVBDC10
0606110038645
DRY AND WET
12 mm
HEXVBDC12
0606110038652
DRY AND WET
16 mm
HEXVBDC16
0606110038676
DRY AND WET
20 mm
HEXVBDC20
0606110038669
DRY AND WET